The default username is pi, and the default password is raspberry.
![]()
When you see that someone installed easycap grabber you may suspect that when you buy one you will have the setup that is ready to use. This is very wrong assumption:) unless you are lucky and this is why. Install Mplayer Raspberry Pi Download It AndDownload it and dump to sd card. Install Mplayer Raspberry Pi How To Distinguish OneYou can check there how to distinguish one version from another based on lsusb output. I wrote usually because I was unlucky enough to buy stk1160 grabber that had awful cropping which is not common issue with this type of grabber. Wait Why did you write almost For some dumb reason, I had to execute the following statement. Maybe I had some faulty piece, becasue I have heard that for others it works well. Be patient, because downloading kernel sources takes a lot of time. My case is that it allows to build ambilight system for any video source (including HDMI source with some additional hardware tutorial on the way). Install Mplayer Raspberry Pi Upgrade On MyI tried this after running an updateupgrade on my new Raspbian install and the folder is now 3.10.25. I adjusted accordingly and all seemed to go well. Once I plug in my EasyCAP (fushicai 007) Linux crashes when I plug in the usb capture card. After rebooting I can delete the module and it works, but I cant load the driver. When I tried to compile and load the driver on newest rasbian, it hanged as soon as i tried to load usbtv module. ![]() Im updating to Raspbian Jessie which is supposed to have kernel 3.12 and the drive built in. ![]() Any ideas Any help would be greatly appreciated BTW Im using LPD8806 LEDs, and have created uploaded a proper config file for hyperion to use. Thanks. It looks like there is something wrong with your hyperion instalation. Run hyperion from command line and see if there is any error. But some how the leds wont lite up; also not with the hyperion remote, althoug its says its synchronized. If I switch the scard with one that Ive configured with the Hyperion on OpenELEC. When I use the lsusb command I can see it there but it doesnt mount. If you have found a solution, or have a disk image of your working setup, I would greatly appreciate it. If you are already running raspbmc you can simply install my rebuilt kernel image from here.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |